Avaya one-X 9600 Series Administrator's Manual page 88

Administering Telephone Options
Table 12: 9600 Series IP Telephone Customizable System Parameters (continued)
Parameter Name
HTTPPORT
HTTPSRVR
ICMPDU
ICMPRED
IDLEFEATURES
IPPREF
IPV6STAT
L2Q
L2QVLAN
88 9600 Series IP Deskphone Administrator Guide Release 6.0
Default Value Description and Value Range
80 TCP port number used for HTTP file downloading. 2 to
5 ASCII numeric digits. Valid values are "80" through
"65535". Note that when the file server is on
Communication Manager, set this value to "81" (port
required for HTTP downloads) rather than the using
the default.
" " (Null) IP Address(es) or DNS Name(s) of HTTP file servers
used to download telephone files. Dotted decimal or
DNS format, separated by commas (0-255 ASCII
characters, including commas).
0 Controls whether ICMP Destination Unreachable
messages will be processed. Values are: 0=No,
1=Send limited Port Unreachable messages, 2=Send
Protocol and Port Unreachable messages.
0 Controls whether ICMP Redirect messages will be
processed. Values are: 0=No, 1=Yes.
" " (Null) A list of feature number identifiers for softkey features
potentially available in the Idle call state, for example,
Redial. Zero to 255 ASCII characters consisting of zero
to six whole numbers separated by commas without
any intervening spaces. For more information, see
Administering Features on Softkeys
6 Applies only to deskphones running software Release
6.0 and later. Specifies which type of IP address (IPv4
or IPv6) will be tried first if DNS returns both types.
Valid values are:
4= Try IPv4 addresses first over DHCPv6 if DNS
returns both types.
6= Try IPv6 addresses first over DHCPv4 if DNS
returns both types.
0 Applies only to deskphones running software Release
6.0 and later. Specifies whether IPv6 will be supported.
Valid values are:
0 = IPv6 is not supported.
1 = Support/enable IPv6.
0 Controls whether Layer 2 frames have IEEE 802.1Q
tags (0=auto, 1=enabled, 2=disabled).
0 802.1Q VLAN Identifier (0 to 4094). Null (" ") is not a
valid value and the value cannot contain spaces. VLAN
identifier used by IP Deskphones. Set this parameter
only when IP Deskphones are to use a VLAN that is
separate from the default data VLAN. If the VLAN
identifier is to be configured via H.323 signaling based
on Avaya Communication Manager administration
forms, it should not be set here.
As of software Release 2.0, L2QVLAN will always be
initialized from the corresponding system initialization
value at power-up, but will not be initialized from the
system initialization value after a reset.
on page 118.
7 of 18