Avaya one-X 9600 Series Administrator's Manual page 108

Administering Telephone Options
A 9600 Series IP Telephone initiates LLDP after receiving an LLDPDU message from an
appropriate system. Once initiated, the telephones send an LLDPDU every 30 seconds with the
following contents:
Table 14: LLDPDU Transmitted by the 9600 Series IP Deskphones
Category
Basic Mandatory
Basic Mandatory
Basic Mandatory
Basic Optional
Basic Optional
Basic Optional
IEEE 802.3
Organization
Specific
TIA LLDP MED
TIA LLDP MED
TIA LLDP MED
TIA LLDP MED
108 9600 Series IP Deskphone Administrator Guide Release 6.0
TLV Name (Type)
Chassis ID
Port ID
Time-To-Live
System Name
System Capabilities
Management Address
MAC / PHY
Configuration / Status
LLDP-MED
Capabilities
Extended
Power-Via-MDI
Network Policy
Inventory – Hardware
Revision
TLV Info String (Value)
IPv4 IP Address of telephone.
MAC address of the telephone.
120 seconds.
The Host Name sent to the DHCP server in
DHCP option 12.
Bit 2 (Bridge) will be set in the System
Capabilities if the telephone has an internal
Ethernet switch. If Bit 2 is set in Enabled
Capabilities then the secondary port is
enabled.
Bit 5 (Telephone) will be set in the System
Capabilities. If Bit 5 is set in the Enabled
Capabilities than the telephone is registered.
Mgmt IPv4 IP Address of telephone.
Interface number subtype = 3 (system port).
Interface number = 1.
OID = SNMP MIB-II sysObjectID of the
telephone.
Reports autonegotiation status and speed of
the uplink port on the telephone.
Media Endpoint Discovery - Class III - IP
Telephone.
Power Value = 0 if the telephone is not
currently powered via PoE, else the
maximum power usage of the telephone plus
all modules and adjuncts powered by the
telephone in tenths of a watt.
Tagging Yes/No, VLAN ID for voice, L2 Priority,
DSCP Value.
MODEL - Full Model Name.
1 of 2