Avaya one-X 9600 Series Administrator's Manual page 111

Table 15: Impact of TLVs Received by 9600 Series IP Deskphones on System Parameter
Values (continued)
System
Parameter Name
L2Q, L2QVLAN,
L2QAUD,
L2QSIG,
DSCPAUD,
DSCPSIG
MCIPADD
TLSSRVR and
HTTPSRVR
L2Q
TLV
Name
MED Network
Policy TLV
Proprietary Call
Server TLV
Proprietary File
Server TLV
Proprietary 802.1
Q Framing
Link Layer Discovery Protocol (LLDP)
Impact
L2Q - set to "2" (off) If T (the Tagged Flag) is set to
0; set to "1" (on) if T is set to 1.
L2QVLAN - set to the VLAN ID in the TLV.
L2QAUD and L2QSIG - set to the Layer 2 Priority
value in the TLV.
DSCPAUD and DSCPSIG - set to the DSCP value
in the TLV.
A check is made as to whether a reset is necessary
to obtain a new IP address due to a change in the
values of the parameters L2Q or L2QVLAN.
This TLV is ignored if:
the value of USE_DHCP is "0" and the value
●
of IPADD is not "0.0.0.0", or
the Application Type is not 1 (Voice), or
●
the Unknown Policy Flag (U) is set to 1.
●
MCIPADD will be set to this value if it has not
already been set.
TLSSRVR and HTTPSRVR will be set to this value
if neither of them have already been set.
The default L2Q is set to the value of this TLV. No
change is made to the current L2 tagging, but the
new default value is used on the next reboot. If TLV
= 1, L2Q set to "1" (On). If TLV = 2, L2Q set to "2"
(Off). If TLV = 3, L2Q set to "0" (Auto).
Issue 8 August 2010 111