Table of Contents
Advertisement
ZyAIR B-5000 User's Guide
21.2.11
Remote Wireless Router-to-Central Wireless Router
Figure 21-9 Remote Wireless Router-to-Central Wireless Router
Step 1.
Set the Central Wireless Router/Bridge to run as a Central Wireless Router; see section
21.2.3 (wireless Interface IP is 192.168.1.1, Ethernet Interface IP is 192.168.2.1, 192.168.2.254
is the factory default.
Step 2.
Set wireless parameters on Central Wireless Router: Channel and SSID.
Step 3.
Set the Remote Wireless Router/Bridge as a Remote Wireless Router; see section 21.2.7
(Wireless Interface IP is 192.168.1.2, Ethernet Interface IP is 192.168.10.1, 192.168.1.1 is the
factory default.
Step 4.
Set wireless parameters on Remote Wireless Router: Channel and SSID, these parameters
must be the same as the Central Wireless Router.
Step 5.
Set the DHCP server service on the Remote Wireless Router and apply it to the Ethernet
Interface.
Step 6.
The Remote Wireless Router assigns IP address to PC1 and PC2.
You can turn 'off' NAT (PAT) on the Central Wireless Router and turn 'on' NAT (PAT) on the Remote
Wireless Router. Any outgoing packets will be translated to address 192.168.1.2.
Central Wireless Router: turn 'off' NAT (PAT) on Wireless Interface and turn 'off' NAT (PAT) on
Ethernet interface.
Remote Wireless Router: turn 'on' NAT (PAT) on Wireless Interface and turn 'off' NAT (PAT) on
Ethernet interface.
21-18
Configuration Scenarios
Advertisement
Table of Contents
