ZyAIR B-5000 User's Guide
LABEL
Back
NEXT
4.3
Quick Setup – Static Route
Static routes tell routing information that a networking device cannot learn automatically through other
means. The need for static routing can arise in cases where RIP (Routing Information Protocol) is disabled on
the LAN or a remote network is beyond the one that is directly connected to a remote node.
Use the Quick Setup – Static Route screen to configure static routes. This screen only applies to the ZyAIR
set up as an access point.
The following table describes the labels in this screen.
LABEL
Static Route Settings
Index
4-12
Click Back to return to the previous screen.
Click NEXT to continue.
Figure 4-6 Quick Setup Static Route
Table 4-7 Quick Setup Static Route
This is the static route number.
DESCRIPTION
DESCRIPTION
Access Point Quick Setup