Configure The Zyair As A Wireless Access Router With Static Ip Address (Fixed Ip) - ZyXEL Communications ZyAIR B-5000 User Manual

Step 12. Click FINISH.
Ensure that interface 3 within Status is set to Disable. In order to enable NAT (PAT)
service; choose the NAT (PAT) in the interface Wireless and Ethernet. For
example, make sure Ethernet interface within NAT (PAT) is set to 'On' and
Wireless interface in NAT (PAT) is set to 'Off'. This means that every
communication through the PPPoE interface is applied to NAT (PAT).
Step 13. Click BASIC CONFIG, select DHCP Parameters and apply the DHCP Client Setting
running as interface 2 (Ethernet Interface). Click FINISH.
Step 14. Set Basic Configuration - Wireless LAN parameters on the ZyAIR: Channel and SSID.
Step 15. Turn on the DHCP server on the ZyAIR and assign IP addresses to PC1, PC2 and PC3.
Step 16. Set wireless parameters on client stations PC1, PC2 and PC3: SSID (wireless).
Figure 21-3 Wireless Access Router with Dynamic IP Address (DHCP Client)
21.1.4 Configure the ZyAIR as a Wireless Access Router with Static IP
Address (Fixed IP)
Step 1. Select ACCESS POINT as the operating mode, click NEXT.
Step 2. Click ADVANCED CONFIG.
Step 3. Select BRIDGING.
Configuration Scenarios
ZyAIR B-5000 User's Guide
21-5