Table 4-6 Quick Setup Tcp/Ip Settings (Wireless Access Router Static Ip Mode) - ZyXEL Communications ZyAIR B-5000 User Manual

Outdoor access point & bridge
Hide thumbs Also See for ZyAIR B-5000:
Table of Contents

Advertisement

Table 4-6 Quick Setup TCP/IP Settings (Wireless Access Router Static IP Mode)

LABEL
TCP/IP Settings
Ethernet Interface
IP
Ethernet Subnet
Mask
Wireless Interface
IP
Wireless Subnet
Mask
Default Gateway
DNS Server
NAT (PAT) allows the translation of an Internet protocol address used within one network to a different IP
address known within another network.
None
Wireless LAN
Ethernet
General DHCP Server Parameters
DHCP Service
Assign Default
Gateway
Assign net Mask
DHCP Start/End IP
Apply Interface
Access Point Quick Setup
Type the IP address of your ZyAIR in dotted decimal notation, for example,
192.168.1.1 is the factory default.
Type the subnet mask assigned to you by your ISP (if given).
Type the IP address of your ZyAIR in dotted decimal notation, for example,
192.168.1.1 is the factory default.
Type the subnet mask assigned to you by your ISP (if given).
Enter the IP address of the default gateway. This applies to Wireless Access
Bridge mode.
ISP dynamically assigns DNS server information (and the ZyAIR's WAN IP address).
The field displays the DNS server IP address that the ISP assigns.
Select this to disable NAT on all interfaces.
Select this to activate NAT on the wireless LAN interface.
Select this to activate NAT on the Ethernet interface.
Select Enable or Disable to activate or deactivate DHCP Service, Disable is the
factory default. When configured as a server, the ZyAIR provides the TCP/IP
configuration for the clients. If this is set to Disable, DHCP service will be disabled
and you must have another DHCP server on your LAN, or else the computers must
be manually configured.
Enter the IP address of the default gateway.
The DHCP server assigns a Subnet Mask.
DHCP Start IP and End IP provide a range of addresses for your network.
Use the drop-down list to select WLAN to make DHCP services available for the
wireless network or select Ethernet, to make DHCP services available for the wired
network.
ZyAIR B-5000 User's Guide
DESCRIPTION
4-11

Advertisement

Table of Contents
loading

Table of Contents