Table of Contents
Advertisement
ZyAIR B-5000 User's Guide
21.2.3
Configure the ZyAIR as a Central Wireless Router with PPP over
Ethernet (PPPoE)
Step 1.
Select BRIDGE as the operating mode, click NEXT.
Step 2.
Click QUICK CONFIG, select Central Wireless Router/Bridge and click NEXT.
Step 3.
Select Central Wireless Router to set this ZyAIR to operate in router mode, you also need to
select the Ethernet connection type in PPP over Ethernet (PPPoE), and then click NEXT.
Step 4.
Configure TCP/IP Parameters.
Step 5.
Enter the Wireless interface IP address, 192.168.1.1 is the factory default and Wireless
interface Net Mask (default is 255.255.255.0) that are suitable for your wireless network.
Step 6.
Specify the Ethernet IP address, 192.168.2.1 is the factory default and Ethernet Net Mask
(default is 255.255.255.0) of the Ethernet interface. If you are a PPPoE subscriber, you may
specify your personal ISP provided PPPoE Username and PPPoE Password to enable
broadband access.
Step 7.
You may have to configure two network settings in the Gateway and DNS tabs of each wireless
client's computer to surf the Internet, or you can enable DHCP server services for all wireless
clients (default DHCP server setting of the ZyAIR is set to disable in the wireless network). In
General DHCP Server Parameters, enter the Assign Default Gateway, Assign Net Mask,
Assign Name Server, DHCP Start IP, DHCP End IP and choose Apply Interface as
HWLAN to make your DHCP server services available for the wireless network.
Step 8.
Click NEXT.
Step 9.
Configure IEEE 802.11b WLAN parameters.
Step 10. Enter the Channel, rts Threshold, frag Threshold, SSID and Station Name that are suitable
for your wireless network and click the radio button. To disable WEP or enable 64/128 bit WEP
services, if WEP is enabled, you must input a corresponding Default Key index and WEP Key.
Step 11. Click NEXT.
Step 12. Review the configured setting of the ZyAIR.
Step 13. Click the SAVE button to store the changes back to your ZyAIR.
Step 14. Click the RESTART button to take effect the configuration changes.
21.2.4
Configure the ZyAIR as a Central Wireless Router with Dynamic IP
Address (DHCP Client).
Step 1.
Select BRIDGE as the operating mode, click NEXT.
Step 2.
Click QUICK CONFIG, select Central Wireless Router/Bridge and click NEXT.
21-10
Configuration Scenarios
Advertisement
Table of Contents
