Configure The Zyair As A Central Wireless Bridge - ZyXEL Communications ZyAIR B-5000 User Manual

The IP addresses displayed shown in the figures in this chapter are
21.2.2

Configure the ZyAIR as a Central Wireless Bridge

Step 1. Select BRIDGE as the operating mode, click NEXT.
Step 2. Click QUICK CONFIG, select Central Wireless Router/Bridge and click NEXT.
Step 3.
Select Central Wireless Bridge operation mode and click NEXT.
Step 4.
Configure TCP/IP Parameters.
Step 5. Enter the Bridge IP Address and Bridge Subnet Mask that are suitable for your network
domain. Click NEXT.
Step 6.
Configure IEEE 802.11b WLAN Parameters.
Step 7.
Enter the Channel, rts Threshold, frag Threshold, SSID and Station Name that are suitable
for your wireless network. Click the radio button to disable WEP or enable 64/128 bit WEP
services, if WEP is enabled, you must input a corresponding Default Key index and WEP Key.
Step 8. Click NEXT.
Step 9. Review the configured settings of the ZyAIR.
Step 10. Click the SAVE button to store the changes back to your ZyAIR.
Step 11. Click the RESTART button to make the configuration changes.
Configuration Scenarios
examples only
ZyAIR B-5000 User's Guide
21-9