Table of Contents
Advertisement
ZyAIR B-5000 User's Guide
LABEL
System Authentication Information
Supervisor ID
Enter the username for this user profile. This will determine the username on login.
This ID name can be up to 16 ASCII characters.
Supervisor
Type a password (up to 16 alphanumeric characters) for this user profile. Note that as
Password
you type a password, the screen displays a (*) for each character you type.
Password
Retype your new system password for confirmation.
Confirm
Administration Information
Host Name
Type a descriptive name for identification purposes. Some ISPs check this name, so it
is recommended you enter your computer's "Computer name". The default host name
is set to HWLAN.
This name can be up to 16 ASCII characters.
Domain Name
Type the domain name (if you know it) here. If you leave this field blank, the ISP may
assign a domain name via DHCP. The domain name entered by you is given priority
over the ISP assigned domain name.
Default Route
IP Address
Type the IP address of the remote network or gateway. The gateway is an immediate
neighbor of your ZyAIR that will forward the packet to the destination. On the LAN, the
gateway must be a router on the same segment as your ZyAIR; over the WAN, the
gateway must be the IP address of one of the remote nodes.
DNS Parameters
DNS Server
Type the DNS server address here. If you do not configure a DNS server, you must
Address 1, 2, 3
know the IP address of a computer in order to access it (the default is set as shown).
FINISH
Click FINISH to save your changes back to the ZyAIR.
Click CANCEL to close the System Setup screen without saving any changes.
CANCEL
.
6-4
Table 6-1 Basic Configuration System Setup
DESCRIPTION
System Setup
Advertisement
Table of Contents
