Table of Contents
Advertisement
ZyAIR B-5000 User's Guide
21.2.7
Configure the ZyAIR as a Remote Wireless Router
Step 1.
Select BRIDGE as the operating mode, click NEXT.
Step 2.
Click QUICK CONFIG, select Remote Wireless Router/Bridge and click NEXT.
Step 3.
Configure the operation mode as a Remote Wireless Router.
Step 4.
Configure TCP/IP parameters.
Step 5.
Enter the Wireless interface IP, 192.168.1.1 is the factory default and Wireless interface Net
Mask (default is 255.255.255.0) that are suitable for your wireless network, and enter the
Default Gateway (Default is 192.168.2.254) as the wireless IP address of the Central Wireless
Router/Bridge. Enter the IP address of the DNS servers provided by your ISP in the DNS
server (Default is 192.168.2.254) field.
Design your network infrastructure and assigned the correct IP address for the
Central Wireless Router/Bridge and the Remote Wireless Router/Bridge.
Step 6.
Configure TCP/IP parameters on Ethernet.
Step 7.
Specify the Ethernet IP address, 192.168.2.1 is the factory default and Ethernet Net Mask
(default is 255.255.255.0) of the Ethernet interface that is suitable for your Ethernet network.
Click NEXT.
Step 8.
Configure Wireless parameters. Enter the Channel, rts Threshold, frag Threshold, SSID and
Station Name that are suitable for your wireless network and then you can click the radio button
to disable WEP or enable 64/128 bit WEP services, if WEP is enabled, you must input a
corresponding Default Key index and WEP Key. Click NEXT.
Make sure the SSID parameter is same as the configuration of the Central
Step 9.
Review the configured setting of the ZyAIR.
Step 10. Click the SAVE button to store the changes back to your ZyAIR.
Step 11. Click the RESTART button to take effect the configuration changes.
Step 12. Click BASIC CONFIG and select Interface Parameters. Click the radio button of the
interface that you want to change and click to MODIFY. In order to enable NAT (PAT)
services choose the NAT (PAT) in the interface Wireless and Ethernet. For example, make sure
that the Ethernet interface within NAT (PAT) is turned 'off' and that the Wireless interface
within NAT (PAT) is turned 'on'.
21-14
Wireless Router/Bridge.
Configuration Scenarios
Advertisement
Table of Contents
