Figure 25 Wireless : Bridge/Repeater; Table 13 Wireless : Bridge/Repeater - ZyXEL Communications ZyAIR G-3000 User Manual

Figure 25 Wireless : Bridge/Repeater

The following table describes the bridge labels in this screen.

Table 13 Wireless : Bridge/Repeater

LABEL
WLAN Adaptor
Operating Mode
Enable WDS Security Select the check box to enable WDS on your ZyAIR. A Wireless Distribution
#
Active
Chapter 5 Wireless Configuration and Roaming
DESCRIPTIONS
Select Built-in from the drop down list box to configure your ZyAIR using the
internal WLAN card. Select Removable from the drop down list box to
configure your ZyAIR using a WLAN card adaptor using the extension card slot.
Note: This field is only available when you have an external
wireless card inserted in the ZyAIR.
Select Bridge/Repeater in this field to display the screen as shown in .
System (WDS) is a wireless connection between two or more APs.
When you select the check box, you are prompted to type a Pre-Shared Key
(PSK). The ZyAIR uses TKIP to encrypt traffic on the WDS between AP's.
Note: Other AP's must use the same encryption method to
enable WDS.
This is the index number of the bridge connection.
Select the check box to enable the bridge connection. Otherwise, clear the
check box to disable it.
ZyAIR G-3000 User's Guide
68