Install The Log Assembly - Heat & Glo Escape-I35FB Owner's Manual

H. Install the Log Assembly
Log Set Assembly: LOGS-I30FB
Models: Escape-I30FB, Escape-I30FB-LP
CAUTION: Logs are fragile, handle with care.
1
SRV2201-701
6
SRV2201-706
4
SRV2201-704
PILOT BRACKET
BURNER LEDGE
LIGHT HOLES
GRATE BAR
GRATE TINES
Figure 2. Reference Points
LOG TOUCHES SIDE
OF FIREBOX
FLAT SPOT
FOR LOG #6
Figure 4. Place Log #1
Glass Rock (2201-853): Fill each light hole evenly with the glass rock. Use all of the provided glass rock.
Log #1 (SRV2201-701): See Figure 2 and Figure 5 for additional references. Position Log #1 as shown above. Rest the
rear burner ledge steps, located on the bottom of the log, on the burner ledge. Slide the log forward, until the burner ledge
steps contact the vertical wall of the burner top. Ensure the right side of the log is touching the fi rebox. See Figure 4.
32
5
SRV2201-703
2
SRV2201-702
3
SRV2201-705
BURNER LEDGE
LOG PINS
1
Heat & Glo • Escape-I35FB, Escape-I30FB • 2201-900 Rev. K • 5/11
Figure 1. Logs Installed
GLASS ROCK/MEDIA
Figure 3. Fill Light Holes with Glass Rock
VERTICAL PORTION OF BURNER TUB
RESTS AGAINST THIS LINE
BURNER LEDGE STEPS
RIGHT
END
THIS AREA RESTS ON THE BURNER TOP
Figure 5. Bottom View of Log #1
LEFT
END