Heat & Glo Escape-I35FB Owner's Manual page 34

H. Install the Log Assembly
Log Set Assembly: LOGS-I35FB
Models: ESCAPE-I35FB, ESCAPE-I35FB-LP
CAUTION: Logs are fragile, handle with care.
Figure 1. Log Set Installed
Figure 3. Glass Rock in Place
Glass Rock (2201-853): Fill each light hole with the glass rock. Use all of the provided glass rock.
Log #1 (SRV2202-702): See Figure 2 for additional references. Position Log #1 as shown in Figure 4. Rest the left end of
Log #1 on the burner ledge. The pilot bracket will support the center of the log. The far left end of Log #1 should touch the
left fi rebox wall. The log knot should touch the back fi rebox wall.
34
GLASS ROCK
Heat & Glo • Escape-I35FB, Escape-I30FB • 2201-900 Rev. K • 5/11
5
SRV2202-705
6
SRV2202-706
1
SRV2202-702
BURNER LEDGE
BRACKET
LIGHT HOLES
GRATE BAR
GRATE TINES
Figure 2. Reference Points
LOG TOUCHES FIREBOX
FLAT SPOT
FOR LOG #5
1
BURNER LEDGE
Figure 4. Log #1
4
SRV2202-703
2
SRV2202-701
3
SRV2202-704
PILOT
BURNER LEDGE
LOG PINS
LOG KNOT
LOG RESTS ON
PILOT BRACKET
REST LOG ON