Table of Contents
Advertisement
D. Install the Log Assembly and Lava Rock
Note: If using a glass media or stone kit, skip this section. Refer to the instructions included with the kit.
Log Set Assembly: LOGS-550F
Models: SL-550F, SL-550F-LP, SL-5F
4
5
3
Figure 1.
CAUTION: Logs are fragile, handle with care. Log #1 (2297-700): Place Log #1 into position by holding it upright and
placing it onto the pins on the back of the basepan. See Figure 3. Log #1 will sit upright as shown in Figure 4.
HOLES FOR LOG LOCATION PINS
Figure 3. Log #1 - Bottom View
Log #2 (2033-709): Log #2 has holes on the bottom side that will be used for positioning them in the firebox. See Figure
5. Place Log #2 on the pins in the front of the firebox as shown in Figure 6.
HOLES FOR LOG LOCATION PINS
Figure 5. Log #2 - Bottom View
1
5
2
Heat & Glo • SL-5F, SL-7F Installation Manual • 2499-980 Rev. L • 10/19
LOG PLACEMENT INSTRUCTIONS
LOG PLACEMENT PINS
(CIRCLED)
1
Figure 2. Location of Log Placement Pins and Corresponding Log #'s
Figure 4. Log #1 in Position
Figure 6. Log #2 in Position
1
1
1
2
51
Advertisement
Table of Contents
