Install The Log Assembly - Heat & Glo TRUE-36S-IFT Installation Manual

H. Install the Log Assembly
Log Set Assembly: LOGS-TRUE36
Models: TRUE-36C, TRUE-36H, TRUE-36S, TRUE-36G-IFT, TRUE-36H-IFT, TRUE-36S-IFT,
TRUE-42C, TRUE-42H, TRUE-42S, TRUE-42G-IFT, TRUE-42H-IFT, TRUE-42S-IFT
Note: Refractory appearance and material will vary depending on fi replace model.
LOG PLACEMENT TABS LOG PLACEMENT TABS
Figure 1.
CAUTION: Logs are fragile, handle with care.
NOTICE: If small chips and/or scratches are present, repair them using the included paint touch-up kit.
Log #1 (2280-701 for TRUE-36, 2281-701 FOR TRUE-42): Locate log placement notch on the bottom of log #1. See Figure
2. Mate outer notches on the bottom of Log #1 with the left and right grate tines. Slide Log #1 toward the rear of appliance
until back side of Log #1 contacts the log placement tabs. See Figures 1-3.
Figure 3.
Log #2 (2280-702 for TRUE-36, 2281-702 for TRUE-42): Locate log placement notch on the bottom of Log #2. See Figure
4. Mate notch on the bottom of Log #2 with the center and right grate tines. Slide log toward rear of appliance until right
end contacts the side grate tine. See Figure 5.
Log #2 (TRUE-36 ): Log #2 will be about 1 inch from the
back of the center grate tine when properly placed. See
Figure 5.
Log #2 (TRUE-42 ): Log #2 will contact center log
placement tab on center grate tine. See Figure 5.
60 Heat & Glo • TRUE-36-IFT, TRUE-42-IFT, TRUE-50-IFT Installation Manual • 2461-980 Rev. B • 2/17
LOGS-TRUE42
TRUE-42 ONLY TRUE-42 ONLY
1 1
LOG PLACEMENT INSTRUCTIONS
NOTCH FOR LOG #6 NOTCH FOR LOG #6
LOG PLACEMENT NOTCH LOG PLACEMENT NOTCH
Figure 2.
2 2
BURNED AREA BURNED AREA
LOG PLACEMENT NOTCH LOG PLACEMENT NOTCH
2 2
LOG PLACEMENT SLOTS LOG PLACEMENT SLOTS
Figure 4.
1 1
LEFT SIDE TOWARD REAR
Figure 5.
FLAT SPOT FOR LOG #3 FLAT SPOT FOR LOG #3
1 1
3 3
LOG CONTACTS LOG CONTACTS
SIDE GRATE TINE SIDE GRATE TINE
NOTCH FOR NOTCH FOR
LOG #3 LOG #3
2 2