Table of Contents
Advertisement
E. Install the Log Assembly
LOGS-MSR
4
3
5
2
CAUTION:
Logs are fragile! Carefully remove the logs
from the packaging. Remove the cardboard support from
inside of fireplace.
INDENT
INDENT
STEP 2.
LOG #1 (SRV2005-701): Use the indent on the bottom side of the log to position the large end of the log onto
the grate bar as shown. Slide the log back until the indent engages the grate tine as shown above. Position the thin end of
log #1 one inch from port pattern as shown.
GRATE BAR CUTOUT
STEP 3.
LOG #2 (SRV2005-700): Position log #2 on the left grate bar and the pilot assembly. Use the cut out notches
on the log to position it as shown.
64
Heat & Glo • ST-36TR-IFT, PIER-36TR-IFT Installation Manual • 2482-980 Rev. D • 3/19
1
6
BOTTOM VIEW
BACK VIEW
PILOT
ASSEMBLY
CUTOUT
LOG PLACEMENT INSTRUCTIONS
PILOT ASSEMBLY
STEP 1.
Before positioning the logs, refer to the installation
manual for electric ember set-up and ember placement.
1-inch
2
GRATE TINE (HIDDEN)
1
GRATE
BAR
1
Advertisement
Table of Contents
