Programming The Rc300 To The Control Module - Heat & Glo Escape-I35FB Owner's Manual

Note: if any of the original wire as
supplied with the appliance must
be replaced, it must be replaced
with type 105 °C rated wire.
Note: use zip ties to restrain
the loose wires underneath the
appliance and keep them away
from the blower wheel (fan blades).
PLUG INTO 120V
EXISTING OUTLET
DC REGULATOR
RECEPTACLE
BLK
BLOWER
RECEPTACLE
BLK
Figure 10.3 Fan Wiring Diagram
G. Programming the RC300 to the Control
Module
CAUTION! Risk of burns! DO NOT program the remote
control to the control module when fi replace is hot.
• Refer to the RC300 Installation Instructions included
in appliance manual bag to program the RC300 to the
control module.
28
BLOWERS
Heat & Glo • Escape-I35FB, Escape-I30FB • 2201-900 Rev. K • 5/11
PLUG TO
EXISTING
OUTLET
BROWN
RED
BLACK
GROUND (TO VALVE BRACKET)
GREEN (TO VALVE)
ORANGE (TO VALVE)
WHT BLK
GRN GRN
BLK
BLK
BLK BLK
GRN
GRN
WHT
BLK
BLOWERS