Ember Placement - Heat & Glo Escape-I35FB Owner's Manual

G. Ember Placement
WARNING! Risk of Explosion! Follow ember placement
instructions in manual. DO NOT place embers directly over
burner ports. Replace ember material annually. Improperly
placed embers interfere with proper burner operation.
Ember material is shipped with this gas appliance. To place
the ember material:
• Embers CANNOT be placed directly over ports. Care
should be taken not to cover the lighting trail of ports
(from back to front).
• Place dime-size pieces of Glowing Embers® just in front
of the port trail, but not on or in between the ports. See
Figure 12.2 (Escape-I30FB) or Figure 12.3 (Escape-
I35FB). Care should be taken so that the ports are not
covered. Failure to follow this procedure will likely cause
lighting and sooting problems.
• Save the remaining ember materials for use during
appliance servicing. The embers provided should be
enough for 3 to 5 applications.
EMBERS NOT
ALLOWED IN
PILOT AREA
Figure 12.2 Placement of Embers-Escape-I30FB
EMBERS NOT
ALLOWED IN
PILOT AREA
Figure 12.3 Placement of Embers-Escape-I35FB
Heat & Glo • Escape-I35FB, Escape-I30FB • 2201-900 Rev. K • 5/11 31