Install The Log Assembly - Heat & Glo 6000CBV-IPI Owner's Manual

G. Install the Log Assembly
LOCATING HOLES
FIBER BURNER TOP
BURNER SHIELD
BURNER ASSEMBLY
GUIDE SLEEVES
Figure 1
CAUTION: Logs are fragile, handle with care. Log #1 (SRV2164-701): Locate log placement tabs on the pilot cover (see
Figure 2). Locate the log placements slots on the bottom of Log # 1 (see Figure 3). Mate the slots located on the bottom of
Log #1 with the log placement tabs on the pilot cover. Log # 1 is properly installed when it sits squarely and completely on
pilot cover with tabs engaged (see Figure 4).
f i r e - p a r t s . c o m
LOG PLACEMENT SLOTS LOG PLACEMENT SLOTS
Figure 3
Figure 4 shows the log placement tabs located on the top of Log # 1. The tabs will be mated with the slots located on the
bottom of Log #2 and Log #3 (see Figure 5). Log #2 and Log #3 also have grooves that allow the logs to be seated properly
on the grate (see Figure 5). Hold Log #1 upright while placing Log #2.
Bottom view of Bottom view of
Logs # 2 and 3 Logs # 2 and 3
3 3
GROOVES GROOVES
Figure 5
Log #2 (SRV2164-702): Mate the slot located on the bottom of Log #2 with the left tab on top of Log #1. After slot and tab
have been fi tted together, mate the groove located on the bottom of Log #2 with the horizontal grate bar and slide Log # 2
toward the left until it rests against the far left grate tine.
TAB BENT IN = NG
PILOT COVER
TAB NOT BENT = LP
SLOTS SLOTS
2 2
Heat & Glo • 6000CBV-IPI, 8000CBV-IPI • 2167-900 Rev. C • 9/09
LOG PLACEMENT TABS LOG PLACEMENT TABS
LOG PLACEMENT INDENTATIONS LOG PLACEMENT INDENTATIONS
GRATE TINE GRATE TINE
Figure 2. Firebox Shown with Optional Refractory
LOG PLACEMENT TABS LOG PLACEMENT TABS
Figure 4
LEFT GRATE TINE LEFT GRATE TINE
2 2
Figure 6
Log Assembly: LOGS-6C
1 1
1 1
37