Log on to the controller applications
User modes
The Océ Power Logic
Key operator
Repro operator
System administrator
Service operator.
Chapter 1 contains more information about the types of users (see 'The Océ
TDS400-CS users' on page 18). Chapter 12 contains more information about
the user modes in the Océ Settings Editor (see 'Introduction to the Océ Power
Logic® controller: Océ Settings Editor' on page 31). Log on to the correct user
mode in the Océ Settings Editor to change the key operator settings or the
system administrator settings.
Only assigned operators are allowed to use the user modes. Different
passwords are required to access the user modes.
You do not need a password for the anonymous user mode.
Passwords
The default password for the system administrator is SysAdm .
The default password for the key operator is KeyOp .
The default password for the repro operator is ReproOp .
When a user is logged on, the user can change the password for the current user
mode. (see 'Change the password' on page 70)
The passwords are case sensitive.
Note:
Get to know the Océ Power Logic® controller applications
®
controller has the following user modes.
71