Table of Contents
Advertisement
Setting
Drawing
method
Binding
method
Binding edge
value
Folded package
length
Folded package
width
232
User manual
Menu path
Description
'Folding'
Use this setting to select a folding method that
-'Input'
depends on the drawing method you use. If you
-'Method'
select 'Afnor' you can define the length, the width
and the binding edge of your folded package.
(see 'Define the drawing method' on page 235)
'Folding' -
'Binding'
-'Method'
(see 'Define the binding method' on page 236)
Note:
has a reinforcement unit. (see 'The reinforcement
unit' on page 240)
'Folding'
Determines the width of the strip if you have
-'Binding edge'
selected that your binding method is 'On'.
-'Method'
(see 'Define the binding edge value' on page 237)
'Folding' -
Select this setting if you want to define the length of
'Package' -
your folded output.
'Length'
(see 'Define the folded package length' on
page 238)
'Folding'
Select this setting if you want to define the width of
-'Package'
your folded output.
-'Width'
(see 'Define the folded package width' on page 239)
Select 'Standard' if.....
Select 'Afnor' if...
Select 'Ericsson' if...
Select 'Off' if you don't want your folded output
to have a strip that you can perforate for filing
purposes.
Select 'On' if you do want your folded output to
have a strip that you can perforate for filing
purposes.
Select 'Reinforce' if you want your folded output
to have a reinforced strip that is pre-perforated
for filing purposes.
You can only choose 'Reinforce' if your folder
Advertisement
Table of Contents
