Table of Contents
Advertisement
How to copy a specific area of an original
Place the original face down and right aligned.
1.
The scanner takes the original.
Define the job settings.
2.
Select 'Copy' with the upper-left softkey.
The copy job templates appear.
Open a copy job template with a left softkey.
The top 5 settings appears.
Scroll to 'Remove strip' and open this setting with the left softkey.
Define the 'Leading' strip value with the scroll wheel or numeric keys.
Select 'Trailing' with the left softkey and define the value with the scroll
wheel or numeric keys.
Select 'Left' with the left softkey and define the value with the scroll wheel
or numeric keys. 'Left' is the left side of an original that is turned face up.
Select 'Right' with the left softkey and define the value with the scroll wheel
or numeric keys and close the setting. 'Right' is the right side of an original
that is turned face up.
Scroll to 'Alignment' and open this setting with the left softkey.
Define the value of the 'Horizontal' setting to 'Centre' with the scroll wheel.
Select 'Vertical' with the left softkey and define 'Centre' with the scroll
wheel.
The 'Leading'
strip
Define the number of copies if necessary and press the green start key.
3.
To measure the size of a strip you can use the ruler available at the
Note:
scanner (metric).
Result
The Océ TDS400-CS copies a specific area of the original to the specified
position on the copy.
206
User manual
The 'Trailing'
strip
The 'Left' strip
The 'Right' strip
Advertisement
Table of Contents
