Table of Contents
Advertisement
Limitless™ WDRR Receiver
2.8
Agency Compliance Information
2.8.1 FCC Compliance Statements
•
This device complies with Part 15 of FCC Rules and Regulations. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference and (2) this device must accept any
interference received, including interference that may cause undesired operation.
•
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with these instructions, may
cause harmful interference to radio communications. Operation of this equipment in a residential area
is likely to cause harmful interference in which case the user will be required to correct the interference
at his/her own expense.
•
Intentional or unintentional changes or modifications must not be made to the WDRR unless under the
express consent of the party responsible for compliance. Any such modifications could void the user's
authority to operate the equipment and will void the manufacturer's warranty.
2.8.2 IC Compliance Statements
•
To reduce potential radio interference to other users, the antenna type and its gain should be chosen
so that the equivalent isotropic radiated power (EIRP) is not more than that permitted for successful
communication.
•
Operation is subject to the following two conditions: (1) this device may not cause interference, and (2)
this device must accept any interference, including interference that may cause undesired operation of
the device.
•
This Class B digital apparatus has been tested and found to comply with Canadian ICES-003.
•
French: Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
2.8.3 Radio Frequency (RF) Safety Statement (FCC & IC)
To comply with FCC's and Industry Canada's RF exposure requirements, the following antenna installation and
device operating configurations must be satisfied.
•
Remote antenna for this unit must be fixed and mounted on outdoor permanent structures with a
separation distance between any other antenna(s) of greater than 20 cm and a separation distance of
at least 20 cm [7.87 in] from all persons.
•
Furthermore, when using an integral antenna with the WDRR, it must not be co-located with any other
antenna or transmitter device and have a separation distance of at least 20 cm [7.87 in] from all
persons.
2.8.4 European Restrictions
•
Information regarding national restrictions can be found in document: ERC/REC 70-03 (Relating to the use
of short-range devices including appendixes and annexes). Documentation may be found in the document
database in the European Communication's office.
•
http://www.erodocdb.dk/doks/dochistory.aspx?docintid=1622
50063987
Issue 1,
Honeywell Sensing and Control
7
Hide quick links:
Advertisement
Table of Contents
