Ipv6 Neighbor Setup - ZyXEL Communications GS1920-24 User Manual

Basic Setting > IPv6 > IPv6 Configuration > IPv6 Neighbor Discovery Setup (continued)
Table 25
LABEL
Cancel
Clear
Index
Interface
DAD Attempts
NS Interval
Reachable
Time
8.10.8

IPv6 Neighbor Setup

Use this screen to create a static IPv6 neighbor entry in the Switch's IPv6 neighbor table to store
the neighbor information permanently.
Configuration screen to display the screen as shown next.
Basic Setting > IPv6 > IPv6 Configuration > IPv6 Neighbor Setup
Figure 63
The following table describes the labels in this screen.
Basic Setting > IPv6 > IPv6 Configuration > IPv6 Neighbor Setup
Table 26
LABEL
Interface Type
Interface ID
Neighbor
Address
Chapter 8 Basic Setting
DESCRIPTION
Click Cancel to begin configuring this screen afresh.
Click Clear to reset the fields to the factory defaults.
This is the interface index number. Click on an index number to change the settings.
This is the name of the IPv6 interface you created.
This field displays the number of consecutive neighbor solicitations the Switch sends for this
interface.
This field displays the time interval (in milliseconds) at which neighbor solicitations are re-
sent for this interface.
This field displays how long (in milliseconds) a neighbor is considered reachable for this
interface.
DESCRIPTION
Select the type of IPv6 interface for which you want to configure. The Switch supports the
VLAN interface type for IPv6 at the time of writing.
Specify a unique identification number (from 1 to 4094) for the interface.
A static IPv6 neighbor entry displays in the Management > Neighbor Table screen only
when the interface ID is also created in the Basic Setup > Interface Setup screen.
To have IPv6 function properly, you should configure a static VLAN with the same ID number
in the Advanced Application > VLAN screens.
Specify the IPv6 address of the neighboring device which can be reached through the
interface.
GS1920 Series User's Guide
Click the link next to IPv6 Neighbor Setup in the IPv6
82