ZyXEL Communications GS1920-24 User Manual page 214

Gs1920 series intelligent layer 2 gbe switch
Hide thumbs Also See for GS1920-24:
Table of Contents

Advertisement

Advanced Application > IP Source Guard > ARP Inspection > Log Status
Figure 155
The following table describes the labels in this screen.
Advanced Application > IP Source Guard > ARP Inspection > Log Status
Table 98
LABEL
DESCRIPTION
Clearing log status
Click Apply to remove all the log messages that were generated by ARP packets and
table
that have not been sent to the syslog server yet.
Total number of logs
This field displays the number of log messages that were generated by ARP packets
and that have not been sent to the syslog server yet. If one or more log messages are
dropped due to unavailable buffer, there is an entry called overflow with the current
number of dropped log messages.
Index
This field displays a sequential number for each log message.
Port
This field displays the source port of the ARP packet.
VID
This field displays the source VLAN ID of the ARP packet.
Sender MAC
This field displays the source MAC address of the ARP packet.
Sender IP
This field displays the source IP address of the ARP packet.
Num Pkts
This field displays the number of ARP packets that were consolidated into this log
message. The Switch consolidates identical log messages generated by ARP packets
in the log consolidation interval into one log message. You can configure this interval
in the ARP Inspection Configure screen.
Reason
This field displays the reason the log message was generated.
dhcp deny: An ARP packet was discarded because it violated a dynamic binding with
the same MAC address and VLAN ID.
static deny: An ARP packet was discarded because it violated a static binding with
the same MAC address and VLAN ID.
deny: An ARP packet was discarded because there were no bindings with the same
MAC address and VLAN ID.
dhcp permit: An ARP packet was forwarded because it matched a dynamic binding.
static permit: An ARP packet was forwarded because it matched a static binding.
In the ARP Inspection VLAN Configure screen, you can configure the Switch to
generate log messages when ARP packets are discarded or forwarded based on the
VLAN ID of the ARP packet.
Time
This field displays when the log message was generated.
Chapter 25 IP Source Guard
See Section 25.9.2 on page 218.
GS1920 Series User's Guide
214
See Section 25.9 on page 215.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Gs1920-24hpGs1920-48Gs1920-48hp

Table of Contents