Ipv6 - ZyXEL Communications GS1920-24 User Manual

Basic Setting > Interface Setup
Figure 54
The following table describes the labels in this screen.
Basic Setting > Interface Setup
Table 17
LABEL
Interface Type
Interface ID
Add
Cancel
Index
Interface Type
Interface ID
Interface
Delete
Delete
Cancel
8.10

IPv6

Use this screen to view the IPv6 interface status and configure Switch's management IPv6
addresses.
Click Basic Setting > IPv6 in the navigation panel to display the IPv6 status screen as shown
next.
Chapter 8 Basic Setting
DESCRIPTION
Select the type of IPv6 interface for which you want to configure. The Switch supports the
VLAN interface type for IPv6 at the time of writing.
Specify a unique identification number (from 1 to 4094) for the interface.
To have IPv6 function properly, you should configure a static VLAN with the same ID number
in the Advanced Application > VLAN screens.
Click this to create a new entry.
This saves your changes to the Switch's run-time memory. The Switch loses these changes if
it is turned off or loses power, so use the Save link on the top navigation panel to save your
changes to the non-volatile memory when you are done configuring.
Click Cancel to reset the fields to your previous configuration.
This field displays the index number of an entry.
This field displays the type of interface.
This field displays the identification number of the interface.
This field displays the interface's descriptive name which is generated automatically by the
Switch. The name is from a combination of the interface type and ID number.
Check the rules that you want to remove in the delete column, then click the Delete button.
Click Cancel to clear the Delete check boxes.
GS1920 Series User's Guide
73