Multiple Rapid Spanning Tree Protocol Status - ZyXEL Communications GS1920-24 User Manual

Advanced Application > Spanning Tree Protocol > MRSTP (continued)
Table 47
LABEL
Apply
Cancel
13.7

Multiple Rapid Spanning Tree Protocol Status

Click Advanced Application > Spanning Tree Protocol in the navigation panel to display the
status screen as shown next. See Section 13.1 on page 112 for more information on MRSTP.
Note: This screen is only available after you activate MRSTP on the Switch.
Advanced Application > Spanning Tree Protocol > Status: MRSTP
Figure 93
The following table describes the labels in this screen.
Advanced Application > Spanning Tree Protocol > Status: MRSTP
Table 48
LABEL
Configuration
Tree
Bridge
Bridge ID
Hello Time
(second)
Max Age (second)
Forwarding Delay
(second)
Chapter 13 Spanning Tree Protocol
DESCRIPTION
Click Apply to save your changes to the Switch's run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top navigation
panel to save your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
DESCRIPTION
Click Configuration to specify which STP mode you want to activate. Click MRSTP to
edit MRSTP settings on the Switch.
Select which STP tree configuration you want to view.
Root refers to the base of the spanning tree (the root bridge). Our Bridge is this switch.
This Switch may also be the root bridge.
This is the unique identifier for this bridge, consisting of bridge priority plus MAC address.
This ID is the same for Root and Our Bridge if the Switch is the root switch.
This is the time interval (in seconds) at which the root switch transmits a configuration
message. The root bridge determines Hello Time, Max Age and Forwarding Delay.
This is the maximum time (in seconds) the Switch can wait without receiving a
configuration message before attempting to reconfigure.
This is the time (in seconds) the root switch will wait before changing states (that is,
listening to learning to forwarding).
Note: The listening state does not exist in RSTP.
GS1920 Series User's Guide
121