Link Aggregation Control Protocol - ZyXEL Communications GS1920-24 User Manual

Advanced Application > Link Aggregation > Link Aggregation Setting
Table 58
LABEL
Group
Apply
Cancel
17.4

Link Aggregation Control Protocol

Click Advanced Application > Link Aggregation > Link Aggregation Setting > LACP to
display the screen shown next. See Section on page 137 for more information on dynamic link
aggregation.
Figure 106
Chapter 17 Link Aggregation
DESCRIPTION
Select the trunk group to which a port belongs.
Note: When you enable the port security feature on the Switch and configure port security
settings for a port, you cannot include the port in an active trunk group.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
Advanced Application > Link Aggregation > Link Aggregation Setting > LACP
GS1920 Series User's Guide
141
(continued)