ZyXEL Communications GS1920-24 User Manual page 84

The following table describes the labels in this screen.
Basic Setting > IPv6 > IPv6 Configuration > DHCPv6 Client Setup
Table 27
LABEL DESCRIPTION
Interface Select the IPv6 interface you want to configure.
IA Type Select IA-NA to set the Switch to get a non-temporary IP address from the DHCPv6 server
for this interface.
Optionally, you can also select Rapid-Commit to have the Switch send its DHCPv6 Solicit
message with a Rapid Commit option to obtain information from the DHCPv6 server by a
rapid two-message exchange. The Switch discards any Reply messages that do not include a
Rapid Commit option. The DHCPv6 server should also support the Rapid Commit option to
have it work well.
Options Select DNS to have the Switch obtain DNS server IPv6 addresses and/or select Domain-List
to have the Switch obtain a list of domain names from the DHCP server.
Information Specify the time interval (from 600 to 4294967295 seconds) at which the Switch exchanges
Refresh other configuration information with a DHCPv6 server again.
Minimum
Apply Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the nonvolatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Clear Click Clear to reset the fields to the factory defaults.
Index This is the interface index number. Click on an index number to change the settings.
Interface This is the name of the IPv6 interface you created.
IA-NA This field displays whether the Switch obtains a non-temporary IP address from the DHCPv6
server.
Rapid-Commit This field displays whether the Switch obtains information from the DHCPv6 server by a rapid
two-message exchange.
DNS This field displays whether the Switch obtains DNS server IPv6 addresses from the DHCPv6
server.
Domain-List This field displays whether the Switch obtains a list of domain names from the DHCP server.
Information This field displays the time interval (in seconds) at which the Switch exchanges other
Refresh configuration information with a DHCPv6 server again.
Minimum
Chapter 8 Basic Setting
GS1920 Series User's Guide
84