Table of Contents
Advertisement
Click Config 2 to save the current configuration settings to Configuration 2 on the Switch.
Alternatively, click Save on the top right-hand corner in any screen to save the configuration
changes to the current configuration.
Note:
Clicking the Apply or Add button does NOT save the changes permanently. All
unsaved changes are erased after you reboot the Switch.
37.2.3
Reboot System
Reboot System allows you to restart the Switch without physically turning the power off. It also
allows you to load configuration one (Config 1) or configuration two (Config 2) when you reboot.
Follow the steps below to reboot the Switch.
In the Maintenance screen, click the Config 1 button next to Reboot System to reboot and load
1
configuration one.
Reboot System: Confirmation
Figure 221
Click OK again and then wait for the Switch to restart. This takes up to two minutes. This does not
2
affect the Switch's configuration.
Click Config 2 and follow steps 1 to 2 to reboot and load configuration two on the Switch.
37.3
Firmware Upgrade
Use the following screen to upgrade your Switch to the latest firmware. The Switch supports dual
firmware images, Firmware 1 and Firmware 2. Use this screen to specify which image is updated
when firmware is uploaded using the web configurator and to specify which image is loaded when
the Switch starts up.
Make sure you have downloaded (and unzipped) the correct model firmware and version to your
computer before uploading to the device.
Be sure to upload the correct model firmware as uploading the wrong
model firmware may damage your device.
Click Management > Maintenance > Firmware Upgrade to view the screen as shown next.
Chapter 37 Maintenance
The following screen displays.
GS1920 Series User's Guide
301
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
