ZyXEL Communications GS1920-24 User Manual page 181

Advanced Application > Multicast > IPv6 Multicast > MLD Snooping-proxy > Filtering
Figure 133
The following table describes the fields in the above screen.
Advanced Application > Multicast > IPv6 Multicast > MLD Snooping-proxy > Filtering
Table 79
LABEL
Active
Port
*
Group Limit
Max Group Num.
Filtering Profile
Apply
Cancel
Chapter 23 Multicast
DESCRIPTION
Select this option to enable MLD filtering on the Switch.
This field displays the port number.
Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use
this row first to set the common settings and then make adjustments on a port-
by-port basis.
Changes in this row are copied to all the ports as soon as you make them.
Select this option to limit the number of multicast groups this port is allowed to
join.
Enter the number of multicast groups this port is allowed to join. Once a port is
registered in the specified number of multicast groups, any new MLD Report
message is dropped on this port.
Select the name of the MLD filtering profile to use for this port. Otherwise, select
Default to prohibit the port from joining any multicast group.
You can create MLD filtering profiles in the Multicast > IPv6 Multicast > MLD
Snooping-proxy > Filtering > Filtering Profile screen.
Click Apply to save your changes to the Switch's run-time memory. The Switch
loses these changes if it is turned off or loses power, so use the Save link on the
top navigation panel to save your changes to the non-volatile memory when you
are done configuring.
Click Cancel to reset the fields to your previous configuration.
GS1920 Series User's Guide
181