ZyXEL Communications GS1920-24 User Manual page 164

The following table describes the labels in this screen.
Advanced Application > Queuing Method
Table 69
LABEL DESCRIPTION
Port This label shows the port you are configuring.
* Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this row first to
set the common settings and then make adjustments on a port-by-port basis.
Note: Changes in this row are copied to all the ports as soon as you make them.
Method Select SPQ (Strictly Priority Queuing), WFQ (Weighted Fair Queuing) or WRR (Weighted Round
Robin).
Strictly Priority Queuing services queues based on priority only. When the highest priority queue
empties, traffic on the next highest-priority queue begins. Q7 has the highest priority and Q0 the
lowest.
Weighted Fair Queuing is used to guarantee each queue's minimum bandwidth based on their
bandwidth portion (weight) (the number you configure in the Weight field). Queues with larger
weights get more guaranteed bandwidth than queues with smaller weights.
Weighted Round Robin Scheduling services queues on a rotating basis based on their queue
weight (the number you configure in the queue Weight field). Queues with larger weights get
more service than queues with smaller weights.
Weight When you select WFQ or WRR enter the queue weight here. Bandwidth is divided across the
different traffic queues according to their weights.
Hybrid- This field is applicable only when you select WFQ or WRR.
SPQ
Select a queue (Q0 to Q7) to have the Switch use SPQ to service the subsequent queue(s) after
Lowest-
and including the specified queue for the port. For example, if you select Q5, the Switch services
Queue
traffic on Q5, Q6 and Q7 using SPQ.
Select None to always use WFQ or WRR for the port.
Apply Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Chapter 22 Queuing Method
GS1920 Series User's Guide
164