Enabling/Disabling Sending Of Snmp Traps On A Port - ZyXEL Communications GS1920-24 User Manual

The following table describes the labels in this screen.
Management > Access Control > SNMP > Trap Group
Table 154
LABEL
Trap Destination
IP
Type
Options
Apply
Cancel
38.3.2 Enabling/Disabling Sending of SNMP Traps on a
From the SNMP > Trap Group screen, click Port to view the screen as shown.
set whether a trap received on the port(s) would be sent to the SNMP manager.
Management > Access Control > SNMP > Trap Group > Port
Figure 229
Chapter 38 Access Control
DESCRIPTION
Select one of your configured trap destination IP addresses. These are the IP addresses of
the SNMP managers. You must first configure a trap destination IP address in the SNMP
Setting screen.
Use the rest of the screen to select which traps the Switch sends to that SNMP manager.
Select the categories of SNMP traps that the Switch is to send to the SNMP manager.
Select the individual SNMP traps that the Switch is to send to the SNMP station.
Traps on page 319 for individual trap descriptions.
The traps are grouped by category. Selecting a category automatically selects all of the
category's traps. Clear the check boxes for individual traps that you do not want the
Switch to send to the SNMP station. Clearing a category's check box automatically clears
all of the category's trap check boxes (the Switch only sends traps from selected
categories).
Click Apply to save your changes to the Switch's run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top navigation
panel to save your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
GS1920 Series User's Guide
311
See SNMP
Port
Use this screen to