Software Setting Problems - Brother DPC-8060 Service Manual

9.2.4.2 Software setting problems

The machine may not print the data correctly if there are incorrect software settings.
(1) "There was an error writing to LPT1: (or BRUSB) for the machine " error message appears.
User Check
(1) Check that the machine cable is not damaged or broken. Check also that the cable is
connected to the correct interface connectors of both the machine and PC.
(2) Check that the correct machine is selected if you have an interface switching device.
(3) Check that the appropriate printer driver is selected as 'Set as Default'. Check also that
the correct print port is set for the selected printer driver.
(4) Check that the machine is not connected to the same port which is also connected to a
mass storage device or scanner. Remove all other devices and connect the port to the
machine only. Turn off the printer status monitor in the device options tab in the printer
driver.
(5) If the print port is set as an ECP port, change it to a normal port.
(6) Try printing the test page referring to
(7) Try resetting the factory settings.
Possible cause
Failure inside
the machine
Main PCB
failure
Step Check
1 Is it possible to print the
test page with the method?
2 Is it possible to print with
another PC and machine
cable?
8.4.5 'Test Pattern 1' in chapter 8.
Result
No Identify the error type, then
refer to the specified section of
this chapter.
No Replace the main PCB.
Yes This problem may appear under
the specified system
environment. Check the
environment which the user
used.
9-18
Remedy
Confidential