Brother DPC-8060 Service Manual page 332

Error Code
(Hex)
BE Scan starting edge detection
error.
BF Duplex scanning cannot be
implemented due to too long
document.
C1-CF Not used.
D0-DF Modem error.
E0-E3 Not used.
E4 Out of recording paper.
(Not used.)
E5 Not used.
E6 Write error in EEPROM.
E7 Not used.
Data scanning error during
E8
transmission.
E9 Not used.
EA Document removed at phase
B.
EB-ED Not used.
EE-F2 Not used.
Internal software error.
F3, F5
(Not used.)
F4 Not used.
F6 PC interface error. (Not used.)
F7-FE Not used.
FF Memory management error.
(Not used.)
Symptom
9-10
Probable Cause
Black markings on the
white-level reference
film inside the scanner
top cover.
CCD defective
Main PCB defective
- The document is too
long.
- ADF front sensor 2
defective
Main PCB defective
Main PCB defective
CCD defective
Main PCB defective
Document front sensor
actuator caught on the
surrounding parts
Sensor PCB defective
Main PCB defective
Solution
Clean the white-level
reference film.
Replace the CCD unit.
Replace the main PCB.
Replace the ADF front
sensor 2.
Replace the main PCB.
Replace the main PCB.
Replace the scanner cover
(scanner unit).
Replace the main PCB.
Correct the surrounding
parts on which the
actuator caught.
Replace the sensor PCB.
Replace the main PCB.
Confidential