(39) Remove the six cup S M3x6 Taptite screws.
(40) Remove the two Flat cable from the Main PCB.
(41) Remove the Protective film.
(42) Pull out the flat cable from the Core.
(43) Remove the Laser unit.
NOTE:
- Be careful not to lose the Protective film attached on the flat cable.
- Do not touch the Laser scanner window directly.
Taptite, cup B M3x6
LD harness
(Flat cable)
Main PCB
Polygon motor
(Flat cable)
Laser unit
Core
Protective film
Fig. 6-28
Polygon motor (Flat cable)
Laser unit
6-17
LD harness (Flat cable)
Taptite, cup B M3x6
Main PCB
Confidential