Brother DPC-8060 Service Manual page 330

Error Code
(Hex)
A2 Document length exceeding
the scan limitation.
During scanning, 90 cm or
longer of a document is
detected.
During document feeding or
ejecting, 400 cm or longer of a
document is detected.
The document rear sensor does
A3
not come ON during document
pull-in operation.
A4 50% or more faulty of white
level data. (Not used.)
FAX scanning failure.
A5
(1st time)
A6 FAX scanning failure. (retry)
A7-A9 Not used.
AA The document cover is opened
when the ADF is used.
AB Not used.
AC Less than 50% faulty of white
level data. (Not used.)
AD-AE Not used.
AF
The scanner is locked.
B0 Not used.
B1 Dark level offset data level
error for scanning.
B2
Gain control data level error
for scanning.
Symptom
9-8
Probable Cause
Front open switch
broken
Document jam
Document jam
Document rear sensor
actuator caught on the
surrounding parts
Document rear sensor
broken
CCD defective
White-level reference
film stained in the
scanner cover
Main PCB defective
Document cover sensor
defective
Scanner lock lever is
not released.
Scanner lock lever
defective
CCD defective
Main PCB defective
CCD defective
Main PCB defective
Solution
Replace the front open
switch.
Remove the jammed
document.
Remove the jammed
document.
Correct the surrounding
parts on which the
actuator caught.
Replace the document
rear sensor.
Replace the scanner cover
(scanner unit).
Replace the main PCB.
(Remove the document on
ADF, then close the
document cover.)
Replace the document
cover sensor.
Open the document cover
and release the scanner
lock lever.
Press the [Stop/Exit] key.
Replace the scanner lock
lever.
Replace the CCD unit.
Replace the main PCB.
Replace the CCD unit.
Replace the main PCB.
Confidential