Kodak Scan Station 700 Administrator's Manual page 90

9-6
4. Enter the device's password. See the section entitled,
"Configuration your device options" in Chapter 4 for more
information.
NOTE: This field can be left blank. Leave this field blank if the
password has not been changed.
5. If desired, enter a name of the group (or location). This name will be
displayed in the grid view. For example, the Scan Station may be
located in the main branch of a corporation.
6. If desired, enter any additional information that is important to you in
the Comment field. For example, you can enter the name of the
department where the Scan Station is located.
7. Click Add. The Scan Station name and information will be displayed
on the Kodak Scan Station 700/720EX - Scanner Administration
main screen.
NOTES:
• If the Scan Station is not found or if you are adding a Scan
Station that will be installed on the network at a later time, the
message, There was an error communicating with the device,
would you like to Add it anyway? will be displayed. Click Yes
to add the Scan Station.
• If an incorrect IP address is entered, you may have to delete the
Scan Station information from the Kodak Scan Station 700/
720EX - Scanner Administration main screen and add it again
with the correct information.
8. Follow Steps 1 - 7 to add additional Scan Stations to this group.
A-61796 December 2013