Kodak Scan Station 700 Administrator's Manual page 34

A-61796 December 2013
7. Enter the email address where you want a notification to be sent
that an email could not be delivered by the Scan Station in the
Return Email Address field. This email address will also be put in
the email From field.
8. If you do not want the user to have the ability to enter an email
address that is not currently in the address book, uncheck the Allow
custom Email Addresses checkbox.
9. If you do not want the user to have the ability to enter information in
the subject line when scanning to email destinations, uncheck the
Allow custom Email Subject checkbox.
10. Select the security type to setup a secure connection to your email
server. Selections are: None, SSL or Use StartTLS.
• SSL: select this option if your email server requires Secure
Socket Layer (SSL).
• Use StartTLS: select this option if you want to enable a secure
SMTP connection.
NOTE: If selected, make sure your email server is configured to
use StartTLS. If it is not, the Scan Station will fail to send an
email.
11. Click Test Connection if you want to check to be sure your settings
are correct. When finished, a Success or Failure message will be
displayed. If the test connection failed, verify that all of your settings
are correct and make any necessary changes, until a Success
message is displayed.
NOTE: You may need to use the scroll bar to access the Test
Connection button.
Depending on the options you selected on the main Device Settings
screen, you will have the option of clicking Next which will display the
next device you want to configure, or Finish which will return you to the
Configuration tab.
4-9