Kodak Scan Station 700 Administrator's Manual page 37

Configuring Fax settings
4-12
If you selected to configure Fax, proceed with the following steps.
NOTE: Dial-up fax settings are for the Scan Station 720EX only. Dial-up
configuration settings will be ignored if they are sent to a Scan
Station 700.
Fax settings can be configured to allow the Scan Station to send and
receive faxes.
NOTES:
• Steps 1-8 are for the dial-up modem only (Scan Station 720EX).
• This procedure allows you to configure a number of email addresses.
For a summary of the different email addresses and their use, see
the chart at the end of this section.
1. If desired, enter a fax number in the Sender's Fax Number field.
This number will be displayed on the banner of outgoing faxes.
2. If your phone system requires a number to get an outside line, enter
the prefix that the user needs to enter to access an outside line
(e.g., 9, is frequently used and a comma "," may be used to insert a
pause) in the Outside Line Prefix field. Each comma pauses the
dialing sequence for about 3 seconds. You can use multiple
commas to increase the pause time.
3. Select Modem Country Code to display a list of countries and the
associated codes that configure the modem for use in the selected
country.
A-61796 December 2013