Kodak Scan Station 700 Administrator's Manual page 122

A-61796 December 2013
5. Install each new tire by gently pulling it over the core.
IMPORTANT:Do not overstretch the tire; it may tear.
6. Replace the core assembly in the feed module. You may need to
slide the shaft to the right or left so the core fits properly within the
feed module housing.
7. Repeat the replacement procedure outlined above for the other core
assembly.
8. Reinstall the feed module by aligning the pins and pushing it toward
the left to fit it into position.
9. Reinstall the feed module cover by aligning the tabs in the slots and
pushing the feed module cover down until it snaps into place.
10-11