Kodak Scan Station 700 Administrator's Manual page 50

5-10
Multifeed Ultrasonic Detection — multifeed detection aids in
document processing by detecting documents that may go through the
feeder overlapped. Multifeeds can happen due to stapled documents,
adhesives on documents, or electrostatically charged documents.
Check this option if you want to enable a Multifeed Response when a
multifeed is detected.
• Multifeed Sensitivity — controls how aggressively the scanner will
work to determine if more than one document is fed into the scanner.
Multifeeds are triggered by detecting air gaps between documents.
This allows multifeed detection to be used with job sets containing
documents with mixed thicknesses.
- Low: least aggressive setting and is less likely to detect labels,
poor quality, thick or wrinkled documents as multi-fed documents.
- Medium: use if your job set has varying document thicknesses or
labels attached to the document. Depending on the label material,
most documents with labels should not be detected as a multi-fed
document.
- High: the most aggressive setting. This is a good setting to use if
all documents have a thickness no greater than 20-lb. bond paper.
NOTE: Regardless of the setting, "sticky" notes may still be detected
as multi-fed documents.
• Multifeed Response — select what action you want the Scan
Station to take when a multifeed is detected. With all options, the
condition will be logged in the Scan Station.
- Continue Scanning: the Scan Station will continue to scan.
- Stop Scanning: scanning will stop and you will have to option to
continue scanning or cancel the batch. Verify that the paper path
has been cleared and restart the scan session from the scanning
application.
Maximum Document Length (in.) — allows you to select the
maximum length of the documents in your job. If the Scan Station
detects a document longer than this value, it will determine that a paper
jam has occurred. The default is 14 inches. Maximum length is 160
inches; minimum length is 2.5 inches.
Reverse Page Order — if enabled, the Scan Station will reverse the
order of the scanned images from the order in which the documents
were scanned.
Allow Adding Pages To Scan Job — when enabled, the user can
continue to add pages to a scan job. After all pages in the input tray
have been scanned, a message will be displayed asking if they want to
add more pages. If the user selects Yes, the additional pages will be
scanned and the message will be displayed again until the user selects
No, or the 30-second timeout has occurred.
A-61796 December 2013