Kodak Scan Station 700 Administrator's Manual page 23

A-61796 December 2013
Device Password — displays the Device Password dialog box which
allows you to change the network connection password to the Scan
Station.
NOTE: This device password is used by the Kodak Scan Station 700/
720EX - Scanner Administration to communicate with the Scan
Station.
Refresh Status — displays the current state of the selected Scan
Station(s):
• Idle — the Scan Station is currently active on the network; but not in
use.
NOTE: Any user interaction using the touch screen will put the
Scan Station into the In Use state (see below).
• Scanning — Scan Station is scanning.
• Processing images — the Scan Station is processing images (e.g.,
converting images to PDF).
• Sending email — the Scan Station is sending an email.
• Saving — images are being saved to a USB drive, network folder,
FTP site, or a SharePoint site.
• Printing — the Scan Station is printing images using a remote
printer.
• Scan Completed — the Scan Station has successfully completed
the scanning session. When Done is selected on the Scan Station,
the Scan Station will go into the Idle state.
• Error — the Scan Station failed to complete the scanning session.
When Done is selected on the Scan Station, the Scan Station will go
into the Idle state.
• Cancelled — the scanning session has been cancelled. After the
inactivity time period has been reached, the Scan Station will go into
the Idle state.
• Preview — the Scan Station Preview feature is in use.
• Sending Fax — the Scan Station is sending a fax. This is only
displayed if the Scan Station is not currently scanning.
• Receiving Fax — the Scan Station is receiving a fax. This is only
displayed if the Scan Station is not currently scanning.
• Powering down — the Scan Station is in the process of a power-
down sequence.
• Rebooting — the Scan Station is in the process of being restarted.
• Updating — the configuration file or firmware is currently being
updated.
• In Use — when a USB flash drive is inserted, a user is logging in or is
interacting with the Scan Station, this state is displayed.
• Not found — the Scan Station cannot be found on the network (e.g.,
power is turned off).
3-7