Nvram Update; Firmware Update Notes - Ricoh B064 Service Manual

SOFTWARE UPDATE

NVRAM Update

This procedure describes updating the NVRAM firmware (
NOTE: Before updating NVRAM, the contents of NVRAM should be uploaded to a
PC memory card and then downloaded after updating the NVRAM
firmware (
1. Switch the main power switch off.
2. Disconnect the ADF plug, remove the rear upper cover ( x 2), then remove
the IC card slot cover ( x 1).
3. With it's a side facing up, insert the NVRAM IC card into the slot.
4. Open the front door.
NOTE: The success of the download cannot be guaranteed if the front door is
closed during the download execution.
5. Switch the machine on.
6. After the download is completed, a message on the operation panel will prompt
you to switch the machine off and on.
7. Switch the machine off, remove the IC card, then switch the machine on.
The NVRAM download execution updates everything except the following SP
functions:
SP7003 ***
SP7006 ***
SP7007 ***

Firmware Update Notes

• RA2K Controller Ver. 3.51 (or later), Scanner 2.08 Ver. 2.08 (or later) support
SMTP authentication.
• When installing Ver. 4.01 or later, make sure that you install the RA2K Controller
firmware and other firmware as a set if the Copy Connector Kit or MLB option are
not installed.
• If the Copy Connector Kit or MLB is installed, make sure that you have the
correct firmware for installation. You will need the set of firmware that supports
the Copy Connector Kit and MLB options.
• When updating BCU firmware Ver. 4.x or later, use RA2K controller firmware Ver.
3x or later.
• When updating RA2K controller firmware Ver. 3x or later, use BCU firmware Ver.
4.x or later.
B064 Series/B140 Series/G126
3.12.7).
Total Count
C/O, P/O
Other Device Counters
5-26
3.12.7).
SM