Service Program Mode Tables; Service Table Key - Ricoh B064 Service Manual

5.6 SERVICE PROGRAM MODE TABLES

5.6.1 SERVICE TABLE KEY

Notation
(B064 only)
(B140 only)
[range/step]
Italics
*
DFU
Japan only
SEF
LEF
*1: SP titles without "B064 only" or "B140 only" are for the B064 and the B140
series machines.
SM
This is added to the title of an SP that is for the B064/B065 only.
This is added to the title of an SP that is for the
B140/B141/B142/B143/B163/B228 only.
Example: [–9~+9/0.1 mm]
The default setting can be adjusted in 0.1mm steps in the range ±9.
Note: The default setting for each SP mode is shown on the screen
in the "Initial" box immediately below the entry box. Some of the
default settings for the B064 Series and B140 Series are slightly
different, so be sure to check the "Initial" box on the SP mode
screen.
Comments added for reference.
An asterisk marks the SP's that are reset to their factory default
settings after an NVRAM reset.
Denotes "Design or Factory Use". Do not change this value.
The feature or item is for Japan only. Do not change this value.
Short Edge Feed
Long Edge Feed
5-29
SERVICE PROGRAM MODE TABLES
What it means
*1
B064 Series/B140 Series/G126
*1