File Format Converter (Mlb) (B519) - Ricoh B064 Service Manual

1.16.7 FILE FORMAT CONVERTER (MLB) (B519)

NOTE:
1. This table shows the special firmware versions to use with the Copy Connector
Kit or File Format Converter (MLB option). When you install one of these
options, it is necessary to install these firmware modules together as a set.
Software
RA2K Controller: System B5254108
RA2K Controller: Copy
BCU
Printer/Scanner
NIB/Netfile
LCDC
2. With the Copy Connector/MLB modifications, the machine firmware is divided
into 2 main groups:
1) The Copy Connector/MLB group (this starts with the versions in the table
above)
2) The usual firmware that was used until this time, that is, for machines without
the Copy Connector or MLB options.
Important: Do not mix firmware from these two. Always use firmware from the
same group, or the machine will not operate correctly.
3. The MLB option cannot operate with any of these items installed. You must
remove these before you start the procedure below:
- Wireless LAN board
- IEEE1394 I/F board
- USB2.0 I/F board
- Copy Connector Kit components
4. As shown above, the RA2K controller firmware for the Copy Connector/MLB
group is divided into RA2K System and RA2K Copy. This is because the
firmware is too large to go on one card.
SM
Part Number Version (1st released)
5.07
B5254109 5.07
B5254123 5.03d
B5255204 4.15/5.00
B5254114 3.00/1.79
B5254176 (NA)
2.04
B5254177 (EU)
1-99
MFP OPTIONS: B064 SERIES
B064 Series/B140 Series/G126