Ricoh B064 Service Manual page 384

B140 SERIES AND G126 SERVICE MODE
860 B
HDD startup error at main power on
• HDD is connected but a driver
error is detected.
• The driver does not respond with
the status of the HDD within 30
s.
861 D HDD re-try failure
At power on with the HDD detected,
power supply to the HDD is
interrupted, after the HDD is
awakened from the sleep mode, the
HDD is not ready within 30 s.
863 D HDD data read failure
The data written to the HDD cannot
be read normally, due to bad
sectors generated during operation.
864 D HDD data CRC error
During HDD operation, the HDD
cannot respond to an CRC error
query. Data transfer did not execute
normally while data was being
written to the HDD.
865 D HDD access error
HDD responded to an error during
operation for a condition other than
those for SC863, 864.
866 B SC card error 1: Confirmation
The machine detects an electronic
license error in the application on
the SD card in the controller slot
immediately after the machine is
turned on.
The program on the SD card
contains electronic confirmation
license data. If the program does
not contain this license data, or if
the result of the check shows that
the license data in the program on
the SD card is incorrect, then the
checked program cannot execute
and this SC code is displayed.
867 D SD card error 2: SD card removed
The SD card in the boot slot when
the machine was turned on was
removed while the machine was on.
868 D SD card error 3: SC card access
An error occurred while an SD card
was used.
B064 Series/B140 Series/G126
• HDD is not initialized
• Level data is corrupted
• HDD is defective
• Harness between HDD and board
disconnected, defective
• HDD power connector disconnected
• HDD defective
• Controller board defective
• HDD defective
Note: If the bad sectors are generated at
the image partition, the bad sector
information is written to NVRAM, and the
next time the HDD is accessed, these bad
sectors will not be accessed for read/write
operation.
• HDD defective
• HDD defective.
• Program missing from the SD card
• Download the correct program for the
machine to the SD card
• Insert the SD card, then turn the machine
off and on.
• SD card not inserted correctly
• SD card defective
• Controller board defective
Note: If you want to try to reformat the SC
card, use SD Formatter Ver 1.1.
4-60 SM