Registration And By-Pass Unit Removal - Ricoh B064 Service Manual

PAPER FEED

3.11.15 REGISTRATION AND BY-PASS UNIT REMOVAL

[B]
1. Remove the development unit. (
2. Remove the inner cover. ( x 4)
3. Disconnect the toner bottle holder connector [A] and counter connector [B].
4. Pull out the duplex unit about 10 cm.
• Confirm that the registration roller is separated from the positioning pin.
5. Remove the right upper cover. (
6. Rear upper cover (
7. Disconnect the following connectors:
• Relay clutch connector [C]
• Guide plate solenoid connector [D]
• Guide plate sensor connector [E]
• By-pass tray unit connectors [F]
B064/B140 Series/G126
[A]
3.3.5)
[C]
3.6.1)
3.3.3)
3-112
[D]
[E]
[F]
B140R850.WMF
SM