Ricoh B064 Service Manual page 145

40 to 60 mm
[B]
[A]
[C]
6. Remove the tape from the back of the Velcro patches [A]. Then, attach the
patches to the right rear corner of the main frame. Then attach the antennas [B]
to the patches.
7. Put the connectors through the antenna cap [C].
8. Connect each antenna to a terminal [D] and attach the antenna cap.
NOTE: 1) Attach the antennas as specified above. But, if you change the
location of an antenna, make sure that the antennas are separated
by a minimum of 40~60 mm (1.5~2.5").
2) Install the antennas in an area that is free of interference from
electrical equipment that causes a strong electromagnetic field.
3) Always remove the antennas from the corners of the machine and
disconnect them before you move the machine.
4) If reception is not good, move the machine and antennas more
near to the access point.
9. Turn the machine on and print a configuration page to make sure that the
machine can see the installed IEEE 802.11b interface board:
User Tools> Printer Features> List Test Print> Configuration Page
SM
MFP OPTIONS: B140 SERIES
[D] B659I105.WMF
1-111 B064 Series/B140 Series/G126